SuperDraft Systems CAD / CAM / DNC - Software Manufacturers




It is important that you do not download the wrong version of the software. Changes have been made over the last few years to the way the Alpha lathe runs. We have altered the software to work with these changes. If your machine is a different version than the software was intended for this WILL cause problems when running CAM files.

There is no advantage in downloading v3.21 if your machine is using v1.8, IT WILL NOT WORK!!

Superdraft Systems Limited accept no responsibilty for problems occuring due to using the wrong version of the software. If you are unsure about the level of system your machine is running please contact T.S. Harrisons

Alpha-Link v1.81 - This is the latest software if you are using v1.4, v1.5, v1.6, v1.7 or v1.8

Alpha-Link v2.21 - This is the latest version if you are using v2.0, v2.1 or v2.2

Alpha-Link v3.21 - This is the latest version if you are using v3.0, v3.1 or v3.2

Alpha-MG v1.11 - This is the latest version of the Alpha-MG (1000 Series) software

Alpha-S v5.21 - This is the latest version of the Alpha-S software

Alpha-T v1.22 - This is the latest version of the Alpha-T software

To use the software:

1) Click on one of the links above to download the upgrade. One file will be downloaded to your PC

2) Click on this file i.e. Alpha181.exe to run it. At this point you will need a blank floppy disk and the password to unlock the software. Please contact Superdraft Systems Ltd with your serial number (this can be found on the box the software and cabel came in, on the master floppy or on the Certificate of Terms and Conditions leaflet in the box) and we will give you the password. Please contact us via telephone, fax or e-mail.

3) When the software has been copied to a floppy install the system as usual by inserting the floppy and typing



4) The new system will be copied to your PC. All your existing drawings and programs will be left untouched.



Superdraft Systems Ltd
195 Derby Road,

Tel: 08707 520410